The water dispenser
Why does the dispenser drip after use?
Two or three drops after you take the glass away are the line relaxing, not a fault: the water standing above the spout has nowhere to go but down. A drip that keeps going for minutes, or one that starts when nobody has touched the dispenser, is a valve that failed to seat. Denver Sub-Zero Repair Experts separates the two by the clock rather than by the puddle.
Pattern
What we usually find
- Residual water in the short run above the spout finishing its drain a few seconds after the valve shuts. There is nothing here to repair.
- Grit on the valve seat, so the solenoid drops but a thin path stays open and the drip never quite comes to an end.
- A hardened seal at the spout, holding a bead until it grows heavy enough to fall long after the pour has finished.
- House pressure sitting at the top of the working range, pushing past a seat that would have held at the middle of it.
Most often first. Order comes from what the visits keep turning up, not from a count.
When a drip stops being cosmetic
Time it. Put a dry glass under the spout, draw nothing, and come back in ten minutes. An empty glass means the line settled and you saw the tail of a normal pour. Anything measurable in it means water is passing a closed valve, and that quantity only grows: seats do not recover, and the mineral that is holding one open is being replenished every time the dispenser is used.
Left alone, it stops being a drip on a drip tray and becomes a wet cabinet floor, usually at the point where the tray overflows unnoticed behind a door. It is a small repair caught early and a much larger conversation caught late, so it is worth a call to Denver Sub-Zero Repair Experts on (720) 903-2603 while it is still only a nuisance.
When it needs somebody out: Refrigerator Repair in Denver.